ASROCK H71M-DGS XFAST LAN DRIVER DETAILS:
|File Size:||15.7 MB|
|Supported systems:||Windows 10, 8.1, 8, 7, 2008, Vista, 2003, XP|
|Price:||Free* (*Free Registration Required)|
ASROCK H71M-DGS XFAST LAN DRIVER
Asrock H71M-DGS Motherboard Intel LGA 1155 DDR3 SATA3 USB 2.0 VGA DVI PS/2
Apply thermal interface material onto center of IHS on the socket surface. Apply Thermal Interface Material Step 2. Step 3. Place the heatsink onto the socket.
|Soltek SL-65EP2B||Navigation menu|
|Sony Vaio VPCEC25FX TouchPad Settings||Additional information|
Align fasteners with the motherboard throughholes. Rotate the fastener clockwise, then press down on fastener caps with thumb to install and lock. Repeat with remaining fasteners.
Fan cables on side closest to MB header Fastener slots pointing straight out Press Down 4 Places If you press down the fasteners without rotating them clockwise, the heatsink cannot be secured on the motherboard. Step 5.
Asrock H71M Dgs Owner S Manual DGS_UM
Step 6. Connect fan header with the CPU fan connector on the motherboard. Secure excess cable with tie-wrap to ASRock H71M-DGS XFast LAN cable does not interfere with fan operation or contact other components. Please be noticed that this motherboard supports Combo Cooler Option C.
Otherwise, it will operate at single channel mode. If you install only one memory module or two non-identical memory modules, it is unable to activate ASRock H71M-DGS XFast LAN Dual Channel Memory Technology. It is not recommended to install them on this motherboard. Unlock a DIMM slot by pressing ASRock H71M-DGS XFast LAN retaining clips outward. PCIE slots: Installing an expansion card Step 1. Before installing the expansion card, please make sure that the power supply is switched off or the power cord is unplugged. Please read the documentation of the expansion card and make necessary hardware settings for the card before you start the installation. Remove the system unit cover if your motherboard is already installed in a chassis. Remove the bracket facing the slot that you intend to use.
Keep the screws for later use. Align the card connector with the slot and press firmly until the card is completely seated on the slot. Fasten the card to the chassis with screws.
Replace the system cover. To enable dual monitor feature, please follow the below steps: ASRock H71M-DGS XFast LAN you have installed onboard VGA driver from our support CD to your system already, you can freely enjoy the benefits of dual monitor function after your system boots. Please refer to the following steps to set up a surround display environment: Please refer to page 19 for proper expansion card installation procedures for details.
Boot your system. Press or to enter UEFI setup. Please make sure that the value you select is less than the total capability of the system memory.
If you have installed the drivers already, there is no need to install them again. Set up a multi-monitor display. When you use multiple monitors with your card, one monitor will always be Primary, and all additional monitors will be designated as Secondary.
ASRock > H71M-DGS
Select the display icon identified by the number 2. Repeat steps ASRock H71M-DGS XFast LAN through E for the diaplay icon identified by the number one, two, three and four. Repeat steps A through C for the display icon identified by the number three and four. PCIE Gigabit LAN; Supports Intel HD Graphics with Built-in Visuals; Graphics Supports ASRock Xfast RAM, Xfast LAN, Xfast USB Technologies; Supports.
Supports ASRock XFast RAM, XFast USB, XFast LAN. Technologies. - Supports Intel Smart Connect, Intel Rapid Start. ASRock Graphical UEFI, AXTU.